Hook up asa

hook up asa

How do I connect the power supply to the ASA?

Step 1 Connect the power supply adaptor to the power cable. Step 2 Connect the rectangular connector of the power supply adaptor to the power connector on the rear panel of the ASA. Step 3 Connect the AC power connector of the power cable to an electrical outlet. (The ASA does not have a power switch.

How do I set up a Cisco ASA?

Step 1 Connect one end of an Ethernet cable (not provided) to Ethernet 0 on the ASA. (By default, Ethernet 0 is the Outside interface.) Connect the other end to a cable/DSL modem or gateway router (the Outside network). Step 2 Connect your devices (such as PCs, printers, and servers) with Ethernet cables to Ethernet 1 through 7.

How do I power on the Cisco ASA 5505?

To power on the Cisco ASA 5505, perform the following steps: Step 1 Connect the power supply with the power cable. Step 2 Connect the small, rectangular connector of the power supply cable to the power connector on the rear. Step 3 Connect the AC power connector of the power supply input cable to an electrical outlet.

How to connect Asa command line console to PC?

1 Connect a console port on the Cisco ASA to the serial port on Your laptop/PC with the blue console cable. (If you... 2 Open terminal emulation program like HyperTerminal, TerraTerm or Putty, and onnect to COM serial port on PC (port... 3 On successful connection You should see ASA command line CLI prompt: More ...

How is the ASA powered on?

The ASA is powered on when you plug in the AC power supply. Status LEDs The locations and meanings of the status LEDs are described in LEDs . Network data ports Four Gigabit Ethernet RJ-45 (8P8C) network I/O interfaces.

How do I connect an external device to the ASA?

See Connect to the Console Port with Microsoft Windows for information on installing the driver. The ASA contains one internal USB flash drive, and a standard USB Type A port that you can use to attach an external device. The USB port can provide output power of 5 volts, up to a maximum of 500 mA (5 USB power units).

How to use the management interface on the ASA?

Procedure 1 Management interface – Using this Management 1/1 Gigabit Ethernet port, you can connect a management computer directly with an Ethernet cable, or you can connect the computer and ... 2 Connect the power cord to the ASA, and plug the other end to your power source. ... 3 Check the Status LED on the ASA chassis. ... More items...

How do I deploy the ASA FirePower module to my Network?

Use the following network settings for the ASA FirePOWER module for the recommended network deployment ( 2. Deploy the ASA FirePOWER Module in Your Network ): 4. Register the ASA FirePOWER module to a Firepower Management Center:

Related posts: